Skunk2 intake fittment issue HELP ADVISE
#1
Honda-Tech Member
Thread Starter
Join Date: Mar 2010
Location: indianapolis
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
Skunk2 intake fittment issue HELP ADVISE
ok i have a b16 head ,bought the skunk2 intake manifold installed it,looked amazing lol, well went to put injectors and rail on and the damn injectors wont go into the manifold all the way and i even took out the spacers on the rail studs and there lil more than a quarter inch from seating properly ,i measured the rail mount on the runner on both skunk and stock and theres bout lil more than a quarter inch difference on the runner where the rail mount is placed, anyone ever have this issue???? im definantly pissed ,first build and have had problems nobody has lol
#2
Honda-Tech Member
Thread Starter
Join Date: Mar 2010
Location: indianapolis
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
Re: Skunk2 intake fittment issue HELP ADVISE
not that anyone posted lol but it was a casting defect sent it back to skunk2 and they sent me a new one and even took care of shipping cost everythings in proper workin oreder now
#3
Colonel Cake Mix
Join Date: May 2008
Location: The Bakery
Posts: 15,666
Likes: 0
Received 0 Likes
on
0 Posts
Re: Skunk2 intake fittment issue HELP ADVISE
did skunk2 give any info as to what batch went bad, cause im sure someone else here will run into this problem, and instead of slamming their head against the wall this might be a helpful resource.
Thread
Thread Starter
Forum
Replies
Last Post
BUCK_NASTY
Hybrid / Engine Swaps
2
03-21-2007 03:35 PM