DELshaneSOL

Yesterday I change my tranny with a used new one did my flywheel and clutch kit from compition stage 2 with upgraded plate. I also got the lightweight steel flywheel
Now there's a sound at 2500rpm and it seems to only be at that rpm in gear or in neutral
It sounds like its comming from the tranny and is loud under the car?

92lxsleeper

possibly input shaft bearing, throw out bearing, or pilot bearing

DELshaneSOL

Pilot and throw out are new

DELshaneSOL

Anything eles it could be, I can't really test the tranny because of clutch break in

CivicBlacksheep

Check your fluid level in tranny

tony_2018

loose bolt probably? did you tighten down to spec?

DELshaneSOL

Full with Honda 10w30
76 on fly and 20 on clutch

tony_2018

what about the t bracket bolts and trany bolts, exhaust manifold bolts? Just double check. doesn't hurt to look it over.

Arthas

Honda 10w30? Why didnt you use Honda MTF?

DELshaneSOL

I did Honda mtf I told them what tranny and they gave me the fluid

DELshaneSOL

http://www.youtube.com/watch?v=e8rtvX2eE9I

DELshaneSOL

Up

94EG8

Input/mainshaft bearing in the transmission is toast.

DELshaneSOL

You can tell that from the video nice
About how much is that to fix?
Or is that easy to fix

DELshaneSOL

Will I be ok driving it for a couple months?
And would a shaft beating make noise even when not in gear

94EG8

Sometimes yes, sometimes no. Seriously, I've seen some of them go a long time and do no other damage, sometimes they don't last that long and make a mess of the mainshaft.

Yes.

The bearing is about $20 figure another $5 or so for the seal that goes under it and $20 for a tube of Hondabond. It basically requires completely disassembling the trans, which isn't all that hard as long as you have a manual to go by.