Ran into a little problem installing my ITR Sway and Beaks Kit
#1
Thread Starter
Join Date: Sep 2003
Location: SF, CA, USA
Posts: 833
Likes: 0
Received 0 Likes
on
0 Posts
Ran into a little problem installing my ITR Sway and Beaks Kit
Dont know how i manage to round off the hex part of my endlink while I was taking it off. Dumb thing was, I didn't even need to take that end of the endlink off the car (part connecting to the LCA). Rest of the install went fine, cept my 3/8 drill bit was a little shitty.
I manage to get the nut half way through the tread of the endlink b4 it wouldn't go any further thanks to the rounded off hex. Is there anyway I could solve this problem because everytime i hit a bump, my car makes a loud thump because that end of the sway bar has a little play.
Even with this trouble though, the car turns great.
I manage to get the nut half way through the tread of the endlink b4 it wouldn't go any further thanks to the rounded off hex. Is there anyway I could solve this problem because everytime i hit a bump, my car makes a loud thump because that end of the sway bar has a little play.
Even with this trouble though, the car turns great.
Thread
Thread Starter
Forum
Replies
Last Post
mixmastabob
Honda Civic / Del Sol (1992 - 2000)
5
01-06-2004 09:51 PM