Please Help
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2006
Location: Essex, Ont, Can
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
Please Help
Ok, I am almost done my DD swap on my Del Sol.
I ran into one problem.
I am using a D15B7, and the distributor, I needed to use the ICM out of the D16Z6
1) Are they the same ICM's?
2) I had to wire the ICM in, cause some of the wires were cut on the D15B7 dizzy, and it has a MSD EXT coil.
Problem is, the car turns over, but no spark.
I was wondering if anyone had a diagram, of what color wire goes to what **** on the ICM, as the haynes manual didnt do this for me.
And if anyone knew what wire went where from the blaster cap. (red and white)
No info was available from MSD either
Any help is GREATLY appreciated
Mike
I ran into one problem.
I am using a D15B7, and the distributor, I needed to use the ICM out of the D16Z6
1) Are they the same ICM's?
2) I had to wire the ICM in, cause some of the wires were cut on the D15B7 dizzy, and it has a MSD EXT coil.
Problem is, the car turns over, but no spark.
I was wondering if anyone had a diagram, of what color wire goes to what **** on the ICM, as the haynes manual didnt do this for me.
And if anyone knew what wire went where from the blaster cap. (red and white)
No info was available from MSD either
Any help is GREATLY appreciated
Mike
#2
Honda-Tech Member
Thread Starter
Join Date: Jul 2006
Location: Essex, Ont, Can
Posts: 110
Likes: 0
Received 0 Likes
on
0 Posts
Re: Please Help (rotasol)
Does anyone know anyhting about OBD1 dizzy's?
Sorry for the quick bump, but I need info by tomorrow morning
Thanks again
Sorry for the quick bump, but I need info by tomorrow morning
Thanks again
Thread
Thread Starter
Forum
Replies
Last Post