JUNEK9

My d15b8 1.5L 8 valve had a blown head gasket so I picked up a compete d16y7 swap. To make the swap easier we used the d15 intake and exhaust manifolds. Now everything is in and ready to go. The car cranks over, we have spark and fuel but it just wont start up. Anyone ever do this swap? Need help!!!

ghost_ryder35

check the timing and the vaccum lines, also check compression of the motor

Syndacate

check timing...spark, fuel, and timing is all u need to run ...


Figuratively

Otherguy

Starting fluid? has the motor been sitting for awhile... and i didnt think that the b7 intake mani bolted up right on the y7... plus the ecu is diff... and the motor is OBD2a when the B7 is OBD1

JUNEK9

yeah. the motor actually came out of my car. I sold it to a friend and now we are installing it. It only has 51k on it and ran really well. The intake manifold bolted up however the ports were shaped differently. I think that the motor isnt getting enough air. Just wondering if anyone has done this swap before?

Otherguy

when they do a swap like that ppl use the d16y8 mani, not the b7... i think that might contrib to your problem