need help quick!
#1
Honda-Tech Member
Thread Starter
need help quick!
took off my fuel rail to replace it with a replacement.
I overtorqued it...and broke the threaded part.
is there a way I can replace this?
if so..please provide a pic and a write up.
I need help asap!!
its a 95 civic vx w/ 95 gsr motor
i really dont wanna replace the whole intake manifold just for this stud
I overtorqued it...and broke the threaded part.
is there a way I can replace this?
if so..please provide a pic and a write up.
I need help asap!!
its a 95 civic vx w/ 95 gsr motor
i really dont wanna replace the whole intake manifold just for this stud
#2
Mr. Badwrench
Join Date: May 2002
Location: stranger in a strange land
Posts: 14,146
Likes: 0
Received 2 Likes
on
2 Posts
Re: need help quick! (Sic_DA_Nine)
ok you guys really need to be a little more specific on your thread titles.
broke how? pulled threads out? snapped stud? broke off the ear? is it the middle one or one of the outter ones?
broke how? pulled threads out? snapped stud? broke off the ear? is it the middle one or one of the outter ones?
#3
Re: need help quick! (Sic_DA_Nine)
ok dont panic. this had happened to me once. and the worst part was. it is a type r intake manifold. anyways. what i did was. i used a really sharp stud or long nail and push it against the broke stud..and slightly banged it with a hammer with a circuler motion. it takes time but it will eventually come out.
Modified by crazyguy at 6:10 PM 3/1/2008
Modified by crazyguy at 6:10 PM 3/1/2008
Thread
Thread Starter
Forum
Replies
Last Post
mattmw88
Honda Prelude
3
03-07-2004 10:32 AM