need help Ecu swap p2p - chipped p28
#1
Honda-Tech Member
Thread Starter
need help Ecu swap p2p - chipped p28
I've been running a p2p in my jdm D15B vtec. now i have the p28 chipped for my liking. i installed the jumper and then the p28. when i started the car it would idle at 1k then 1500 then back to 1000 and then 1500 and back. jumping back and forth like the timing is off. the timing is at 16 degrees with the p2p. when i give it gas it cuts out bad and will not pass 3000rpms. wtf. any ideas
Thread
Thread Starter
Forum
Replies
Last Post
stackedhouse
Engine Management and Tuning
3
05-30-2012 03:50 PM