dnt94civic

Okay, I was going to install another clutch master cylinder, but after installation, the clutch kept going to the floor. I bleeded the line, but I still get no pressure from the clutch. Oil comes out from the bleeder screw, but only a little. I thought that it was a messed up clutch master cylinder, but when I swapped back my old one, same thing happened. I am getting no pressure. I only touched the clutch master cylinder, so I don't know what is wrong.

I also installed some new axles since one of my cv boots ripped, but that shouldn't have anything to do with it right?

I'm thinking that I might have messed up my slave clutch cylinder, but I don't see how I could do that.

Please enlighten me.

TIA

SoulSurfer

Same thing happened in my old truck. I had to replace the slave cylinder as well.