redracerk20

hi HT, people, post how much power youre making with your mini-me swap, and pls list all the "bolt-ons"..... im just curios, if theres a thread like this, then pls be nice enough to give me the link....



thanks

handicrx

bump!

im curious too

Ser1N

iTrader: (1)

I cant find the dyno sheets but my friend has one (had one) before he went b18c


he dynoed about 130-/+ # WHP with around 112 WTQ

this it just with header, intake and exhaust. single layer head gasket compression i think was around 10:

I also have a mini me but never took it on the dyno.

andoxviii

iTrader: (1)

Any more info on this setup? Which block? Which head?

I have been thinking of doing a mini-me recently. I have a Y7, but already have a short geared D15B tranny in there. It's begging for a VTEC head...

EFRue57

don't have any dyno #'s but we do have a time slip at the local 8th mile track, but this was in an 89 CRX HF mind you.

89 CRX HF gutted interior and 1/8th tank of fuel - (low fuel = weight reduction, lol)

91 SI A6 block
97 EX Y8 head
91 Integra LS throttle body
Ractive Header
2 1/2 crush bent piping to flowmaster muffler
Autozone special short ram intake
OBD0 b16a ecu
90 LX 5 speed transmission w/ ACT stage2 pressure plate and OEM disc

Ran consistent 9.5's and all put together for less than $500, lol.

I forget what tires we had but they were not that great. I think we could have ran a couple of thenths faster with some better ones.

Ser1N

iTrader: (1)

y8 head, y8 head gasket with 1 layer removed, (forgot what one in the write up) ARP head studs DC headers, full apexi exhaust and aem cold air intake. p28 ECU

dividedas1

search, been covered. old news... way old news. if you even tryed searching i bet you would find a million topics.

a short geared d15b7 trans? just wondering if that's what you were trying to say. or if you are talking about the jdm d15 vtec trans

andoxviii

iTrader: (1)

JDM D15B tranny. Geared like Canadian Si or American EX, I think.

I get less mileage but quicker acceleration...it's a trade-off.

Radyjr

iTrader: (4)

i had a mini-me setup until a few weeks ago. d15b8 block z6 head with a comp cam camshaft, skunk2 cam gear, aem intake, ebay header, apexi ws exhuast system with omni power test pipe, and a z6 transmission on a fidanza 4:3 six puck clutch....

teamworxek9

iTrader: (5)

anyone running one of these with boost, im sure there is. just looking for setups and numbers.