MAF sensor on a D16z6 intake
#1
MAF sensor on a D16z6 intake
I'm swapping my D15b7 for a D16z6. I noticed the new intake has what I believe is a MAF sensor, where my old intake has another vacuum line. I attached some pictures below to show what I mean.
Would you guys just put the old intake on? Or could I plug the vacuum line and run fine? I'm assuming I need to throw the old one on, but I didn't read anything about the z6 intake not being compatible. Anyone else have this issue?
Would you guys just put the old intake on? Or could I plug the vacuum line and run fine? I'm assuming I need to throw the old one on, but I didn't read anything about the z6 intake not being compatible. Anyone else have this issue?
#3
Re: MAF sensor on a D16z6 intake
Thanks man, the last letter was scratched out on the new sensor, I couldn't quite tell.
I also didn't see that the vacuum lines all ran to the old MAP sensor.
Thanks again
I also didn't see that the vacuum lines all ran to the old MAP sensor.
Thanks again
Thread
Thread Starter
Forum
Replies
Last Post
nc0gnito
Honda Civic / Del Sol (1992 - 2000)
4
02-04-2008 10:24 AM
rice a roni
Honda CRX / EF Civic (1988 - 1991)
11
03-12-2007 12:32 PM
SLowCrx
Tech / Misc
1
04-08-2004 03:17 PM
Ignitecivic
Honda CRX / EF Civic (1988 - 1991)
1
11-04-2003 11:40 AM
SOHCEK-Turbo
Honda CRX / EF Civic (1988 - 1991)
6
10-16-2003 09:42 PM