I sould have asked sum1 but now...
#1
Junior Member
Thread Starter
Join Date: Feb 2005
Location: San Diego, CA, U.S.A
Posts: 114
Likes: 0
Received 0 Likes
on
0 Posts
****...can sum1 help me outta this 1?
I just got my '95 civic and and took off the hubcaps to spray wheels black. Well any ways I jacked up my car (literally) to take off wheels and I knew that I put the jack in the wrong spot because my car came down and the jack went right through my driver's floor. I'd expect a girl to do that but not me.. Now I got a hole on the bottom of my car and a lump coming up from the floor on drivers feet. I hammered the lump on the interior down so mommy bear wouldn't notice but still got a hole on the bottom of my car. My babyz in pain...Help me help her. I'd be GR8 if someone could give me advice on what to do now cuz I was just gonna Epoxy the hole to protect it from water gettin in the hole and call it a day. The hole is about 2 1/2 inches around THNX
Modified by '95civic at 7:13 PM 2/14/2005
Modified by '95civic at 7:13 PM 2/14/2005
#3
As long as I dont have to take out any more Metal Gears
Join Date: Aug 2003
Location: Socal, CA, USA
Posts: 2,267
Likes: 0
Received 0 Likes
on
0 Posts
Re: I sould have asked sum1 but now... (Archidictus)
there are some specific jack points behind the wheel well. They are like these U shaped things that u cant miss. If i had my camera back from my sister I'd take a picture for u. Safety is key. U cant enjoy ur car if ur dead
#5
Honda-Tech Member
Join Date: Jul 2003
Location: Orlando, fl, US
Posts: 5,103
Likes: 0
Received 0 Likes
on
0 Posts
Re: I sould have asked sum1 but now... (V-Tech Bauley)
This is funny.. Im sorry it just made me laugh. But yea you can just fill the hole. Or just put another one on the other side and say that its a vent? But epoxy would be good.
#7
Join Date: Nov 2004
Location: Lebanon, Pa, United States
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
who needs floorboards??
haha, almost the same thing happened to my mustang once, but with a jack stand instead, i couldnt get it under where it needed to be so i just stuck it under the floor board until i could move the jack to get the car up higher, well that 2mins it was there, it put a small hole in my floor pan, i just welded a plate over it and then smacked myself.
haha, almost the same thing happened to my mustang once, but with a jack stand instead, i couldnt get it under where it needed to be so i just stuck it under the floor board until i could move the jack to get the car up higher, well that 2mins it was there, it put a small hole in my floor pan, i just welded a plate over it and then smacked myself.
Thread
Thread Starter
Forum
Replies
Last Post