How is your motor you bought from (insert company name here) running after the install???
#1
Thread Starter
Join Date: Mar 2002
Location: R.I.P. Dimebag Darrell, Norman, OK
Posts: 1,013
Likes: 0
Received 0 Likes
on
0 Posts
How is your motor you bought from (insert company name here) running after the install???
yes, i read the big 12 page "where did you get your motor and how did your experience go" thread, and it was very good, but no one really talked about how their motors were running once they were in the cars. so if you have installed one from one of those companies on that list, and had either good or bad luck with it, post up and let us know. im debating where to get mine from, but as you can see, i dont want to get one from a place that sends out troublesome engines. so if you have good info, let us all know
#2
Honda-Tech Member
Join Date: Jul 2002
Location: northern, virginia, USA
Posts: 2,758
Likes: 0
Received 2 Likes
on
2 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
Two of my friends got B16A's from ARD Performanc. One is really strong and runs great. The other is in a CRX and its almost slower than the car was stock. The motor sucks. It runs fine, its ust really weak.
#4
Honda-Tech Member
Join Date: Jun 2002
Location: Atlanta, GA, USA
Posts: 96
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
I bought a 98 GSR and a 96 LS both from Import Auto Salvage...Both went in with out a hitch and run like a dream. Absolutely no problem ...KNOCK ON WOOD . Give Larry Jr or Randy a call, they sell COMPLETE swaps....i even got lug nuts with my swap...
#5
Thread Starter
Join Date: Mar 2002
Location: R.I.P. Dimebag Darrell, Norman, OK
Posts: 1,013
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
bump
[Modified by twinturbobb, 2:34 AM 9/5/2002]
[Modified by twinturbobb, 2:34 AM 9/5/2002]
#6
Honda-Tech Member
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
I got my B16 swap from Japan Direct. Motor was severely washed out inside, stale gas inside the whole engine, and oil was still in it. It had obviously been sitting for a while. Car took forever to get started and smoked for a while but runs strong now.
Trending Topics
#8
Former Moderator
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
I have pirchased my ols B18C1 swap and my girl's B16A2 swap from I.A.S in North Carolina. Both motors ran/run really strong and dynoed about the average for each motor. Every motor I've seen from there ran perfect, and that's like 10 motors total because all my pals bought from them too.
They sell 100% complete swaps with even the hoses uncut - they get my vote.
1-800-962-8922 -ask for Larry Jr. or Randy
Also, my shop just got a full JDM B18C (GS-R) for a customer. Most complete JDM swap I've ever seen. Came with hoses uncut too. I'll tell you how it runs on Mondat night after the guy gets his car.
They sell 100% complete swaps with even the hoses uncut - they get my vote.
1-800-962-8922 -ask for Larry Jr. or Randy
Also, my shop just got a full JDM B18C (GS-R) for a customer. Most complete JDM swap I've ever seen. Came with hoses uncut too. I'll tell you how it runs on Mondat night after the guy gets his car.
#9
Banned
Join Date: Jun 2001
Location: NOVA, America
Posts: 3,702
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
I got a LS changeover from IAS. Engine wise the company is great. Id probably buy another from them.
but......I also baught a rear disk conversion from them and ohhh boy was that a mess.
Engines they are great on, but other stuff there is no real quality control, they gave me 3 bad master cylinders, a bad porportion valve, a bad trailing arm, and a bad ECU
but when I took my valve cover off my motor it looked like they dipped all my internals in platinum
but......I also baught a rear disk conversion from them and ohhh boy was that a mess.
Engines they are great on, but other stuff there is no real quality control, they gave me 3 bad master cylinders, a bad porportion valve, a bad trailing arm, and a bad ECU
but when I took my valve cover off my motor it looked like they dipped all my internals in platinum
#11
Join Date: Aug 2002
Location: Rancho Cucamonga, CA, USA
Posts: 84
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
I picked up a B16A1 from JDMHondaparts.com . Engine runs great, but the syncros on the tranny aren't so great. Transaction with them went smoothly, they had a towing service deliver the front clip to my home since I was only less than 10 miles away.
#14
Honda-Tech Member
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
Got my motor from Evan's Honda Specialist. I got the setup you see below, completely rebuilt with JE pistons, a blockguard and complete turbo kit with intercooler and the works for $6k. That was installed and everything. I've bought 3 engines and my buddy bought a crx and an engine off of these guys and everything has worked and ran FLAWLESSLY! Check out their website and give Chuck a call, tell 'em Heath sent ya and they'll prolly treat ya a little better!
#15
Honda-Tech Member
Join Date: Jan 2002
Location: Sierra Vista AZ
Posts: 2,356
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
b18c5-eh2...you have a shop? is it a garage only?
whats the address?
im in south carolina, and i have found only one worthy import shop, and its 3hours away in myrtle beach
whats the address?
im in south carolina, and i have found only one worthy import shop, and its 3hours away in myrtle beach
#16
Honda-Tech Member
Join Date: Sep 2000
Location: Austin, TX, USA
Posts: 591
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
I got my 96 B18C1 complete swap from Sohfast.com back in November 99, still running strong.
#17
Junior Member
Join Date: Jan 2001
Location: Ancaster, Ontario, Canada
Posts: 333
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
For you Toronto area peeps, I got my JDM B18C1 from Rafal (Honda-Tech name Screamer). He hooked me up with an ITR tranny and 5-lug swap too. Drop him an e-mail at rafal_bulgarski@yahoo.com if you're on the market for an engine or just about anything else OEM. He also has good hook-ups on aftermarket parts like Toda and Spoon, which I loaded up on
#18
Honda-Tech Member
Join Date: Oct 2001
Location: VA/MD/DC, us
Posts: 2,907
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
got three motors from IMPORT AUTO SALVAGE! one of the single cam motors had bad rings but they where quick to send me a replacement no charge. they back up all their motors 100%.. larry jr and randy are really nice and they give you good deals. they try to work with you unlike some of these other import shops. but ias
#19
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
Got my B18C1 from IAS May 2001 and no problems whatsoever. Larry Jr. is a good guy, great customer service, proper delivery time and I even got misc. parts with it including a set of lug nuts.IAS gets
#20
Honda-Tech Member
Join Date: Nov 2001
Location: CALIFORNIA
Posts: 15,366
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
Got my B18C1 from IAS May 2001 and no problems whatsoever. Larry Jr. is a good guy, great customer service, proper delivery time and I even got misc. parts with it including a set of lug nuts.IAS gets
IAS=
#21
Honda-Tech Member
Join Date: Oct 2000
Location: HWY 111
Posts: 2,503
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
onE hondaspecialist
775w rialto ave
california
909 820 4058
cleanest ive seen!
775w rialto ave
california
909 820 4058
cleanest ive seen!
#23
Honda-Tech Member
Join Date: Dec 2001
Location: St Pete, Fl
Posts: 2,732
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install??? (twint
got a b16a1 from K WANTANBE, runs ok but smoke like a bitch(probably my fault since I beat it everyday)in VTEC.
#24
Member
Join Date: Apr 2002
Location: La Primera Guete, United States
Posts: 5,132
Likes: 0
Received 0 Likes
on
0 Posts
Re: How is your motor you bought from (insert company name here) running after the install???
can you guys post up prices also?? that would help a lot too....thanks!!
Thread
Thread Starter
Forum
Replies
Last Post
Acidcrakker
Honda Prelude
31
01-25-2016 09:30 AM
90HFCrX
Honda CRX / EF Civic (1988 - 1991)
2
09-21-2004 11:09 PM
CHONCH
Hybrid / Engine Swaps
19
09-10-2002 06:34 PM