HONDA WIRE GURU WANTED: EG, C101, C102, C103, and C304..PINOUTS needed, like yesterday
#1
Honda-Tech Member
Thread Starter
HONDA WIRE GURU WANTED: EG, C101, C102, C103, and C304..PINOUTS needed, like yesterday
hey guy whats up. workign on a car and its been a theft recovery, let me start out by saying F*CK THEIVES....
ok well the last time this car was stolen the car's chasie harnes was cut, going to rewire the damn conectors and need to run some wire to the ECU also.
i searched C101 pinout-
https://honda-tech.com/zerothread?id=2284848,
and searching "pin out, pinout or pin-out' give me too many quearys.
i looked in my haynes manual and its too general, and my PDF of the FSM is not indexed. i dont know to look threw the fuel section or the electrical...
i need a PINOUT of C101, c102, c103, and c304. i know of the "how to wire VTEC pinouts" but i need the whole connector views.. thanks in advance.
ok well the last time this car was stolen the car's chasie harnes was cut, going to rewire the damn conectors and need to run some wire to the ECU also.
i searched C101 pinout-
https://honda-tech.com/zerothread?id=2284848,
and searching "pin out, pinout or pin-out' give me too many quearys.
i looked in my haynes manual and its too general, and my PDF of the FSM is not indexed. i dont know to look threw the fuel section or the electrical...
i need a PINOUT of C101, c102, c103, and c304. i know of the "how to wire VTEC pinouts" but i need the whole connector views.. thanks in advance.
#2
Honda-Tech Member
Re: HONDA WIRE GURU WANTED: EG, C101, C102, C103, and C304..PINOUTS needed, like yesterday (punkrace
I just wanted to post so I can find this tommorow, but if i get the time I will get on alldata and get the connector views for you
#3
Honda-Tech Member
Re: HONDA WIRE GURU WANTED: EG, C101, C102, C103, and C304..PINOUTS needed, like yesterday (punkrace
this is about the best I can do for you right now but it does cover all your data sensors.
hope that link works
hope that link works
Thread
Thread Starter
Forum
Replies
Last Post
punkracer
Tech / Misc
4
06-23-2008 03:22 PM