98vsmferio

Alright boys and girls...it's time for me to do a little motor work. Here is what I am getting done so read it and tell me if you think it's a good price for install.

I have a stock b18c1 and I am adding:

2001 ITR Cams (same as CTR...as you all know already)
2001 ITR Valvetrain
Skunk2 Intake Manifold
Hondata Inake Manifold Gasket
GSR Throttle Body bored to 64mm to match skunk2 manifold
DC 4-1 Header

They quoted me $350 for all of this. Good deal??? Tell me your opinions.

Thanks.

B2FiNiTY

iTrader: (2)

Not bad as long as the work they do is proper.

MugenHonda

I'd flip out a helms and do it myself
i could never trust anyone except an experienced engine builder to install that

98vsmferio

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by MugenHonda &raquo;</TD></TR><TR><TD CLASS="quote">I'd flip out a helms and do it myself
i could never trust anyone except an experienced engine builder to install that
</TD></TR></TABLE>

They are experienced. It's where I got my motor installed and I trust them very much. I was just wondering about the price.

Do_Ster

seems aiite to me. 250-300 is a little better but then again, you probably have fatter pockets than me

h22John

<TABLE WIDTH="90%" CELLSPACING=0 CELLPADDING=0 ALIGN=CENTER><TR><TD>Quote, originally posted by 98vsmferio &raquo;</TD></TR><TR><TD CLASS="quote">

They are experienced. It's where I got my motor installed and I trust them very much. I was just wondering about the price. </TD></TR></TABLE>sounds good, I would charge you more ................John

wagonis

Depending on what they charge an hour, they're probably getting about 5 or 6 hours labor on that, so that's about fair.