derkaderkder

Just replaced all the OEM junk on my front bumper with some nice heavy duty stainless steel bolts / nuts from lowes.

And my bumper still isn't flush around my head light area, it sits about 1/4" out and the only thing that was orginally holding it to my fender was a plast clip, which I replaced with a nice bolt / nut.

Anyone have any good fixes to bring my bumper closer to my head light? I can't find anything to secure that side of the bumper too and there are only a few places where I could drill new holes for more bolts


EDIT:::DUE TO POST LIMIT PER DAY

http://picasaweb.google.com/Di...64242


Maybe this will help.

Modified by Xathine at 10:39 PM 8/21/2007


Modified by Xathine at 10:39 PM 8/21/2007

95jdmcivic

un loosen the bolts and push the bumper back against the headlights, then tighten the bolts.

derkaderkder

Did, they don't go back any further, and theres nothing anchoring the bumper from one end of the head light untill where there bumper meets my quarter panel, and I can't think of a way to bring it in, with out making my bumper look like a ghettofied POS.

95jdmcivic

so directly under both of your headlights, is there a peice of steel that bolted down with 10mm bolts that hold the front-top of the bumper?

Xathine

iTrader: (2)

I took some of the weather stripping stuff, and just secured it around my headlight, looks ghetto as hell but its a temp fix untill I can afford to get a new bumper, just my .02