NVmyEK

i recently did the mini me swap. it was running good for a while, but just this morning it started acting up. when coasting in any gear. id grab hard when you applied the gas and let off rough when i let off the gas. also to mension oudda the gear if i slightly hit the gas id hit rev limiter (almost like a rev control) at around 1800- 2000 rpm..

( i have OBD1 Dizzy on the head. and the P2P ecu.. is that the problem? possibly defult mode?)

Aquafina

iTrader: (3)

You need to convert to OBD-I and use the P28. How do you expect it to run good when you're running the wrong ECU for the cam you have?

NVmyEK

i do have the p28 ecu but no conv. harness. do you think it will eliminate all this?

Aquafina

iTrader: (3)

Yes. I got my boomslang harness from Kingmotorsports.

You probably need to redo your timing as well. If you set TDC by the mark on the crank pulley, then you're off 4 degrees as the Y runs off 12* and the Z runs off 16*. Set TDC by the piston instead.

NVmyEK

yeah kingmotorsports is a good place. i live 10 min away hehe. um yeah. i have it at about 4.5 degrees off right now. so should that be good?

Aquafina

iTrader: (3)

Put a wooden bbq skewer with sharpie marks on it in cyl 1 and bring it to TDC. Then look at your cam gear. That should tell you roughly how close you are.

NVmyEK

yeah its 4.5 degrees advanced on my cam gear.

Aquafina

iTrader: (3)

Cam gear should be set correctly when cyl1 is at TDC.

NVmyEK

kay. so do u think thats the reason my car is acting up all of a sudden?

NVmyEK

like i said. it only happens once in a while. usually when the engine is warm. also it feeling almost like a trans problem too Help?

Aquafina

iTrader: (3)

Throwing any codes? CYP will make it act funny when warm if its malfunctioning.

NVmyEK

CYP?

Aquafina

iTrader: (3)

cylinder position sensor

NVmyEK

how to fix that?

Aquafina

iTrader: (3)

Are you throwing a code for it? I'm guessing you are.

NVmyEK

idk if i am.

Aquafina

iTrader: (3)

Check to see.