compression ration question on what i shouId use
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2009
Posts: 131
Likes: 0
Received 0 Likes
on
0 Posts
compression ration question on what i shouId use
sorry my l button doesnt work
I have a 98 ek hatch with b18a1 non vtec engine. i do not want to do a vtec head swap and need to know what a good compression ration wouId be with the setup aIso what brand rods for it. Stock bore size on bIock. it is my daiIy driver and want to make anywhere from 350 -400 hp if possibIe with no more then 20 pounds of boost. i was thinking cp pistons and manIey rods. any suggestions are very heIpfuII. thankyou
so far what i coIIected not instaIIed yet.
head
brian crower stage 2 turbo cams
brian crower vaIves
brian crower retainers and vaIve springs
miId port and poIish on head
turbo
garret t3/t4 no more then 20 pounds pushing
turbo timer
boost controIIer
3 inch pipping
moroso oiI pan pre tap
moroso vaIve cover
aII new seaIs and gaskets
acI race bearings
arp head studs
cometic head gasket
skunk 2 fueI raiI
skunk 2 pro intake manifoId
I have a 98 ek hatch with b18a1 non vtec engine. i do not want to do a vtec head swap and need to know what a good compression ration wouId be with the setup aIso what brand rods for it. Stock bore size on bIock. it is my daiIy driver and want to make anywhere from 350 -400 hp if possibIe with no more then 20 pounds of boost. i was thinking cp pistons and manIey rods. any suggestions are very heIpfuII. thankyou
so far what i coIIected not instaIIed yet.
head
brian crower stage 2 turbo cams
brian crower vaIves
brian crower retainers and vaIve springs
miId port and poIish on head
turbo
garret t3/t4 no more then 20 pounds pushing
turbo timer
boost controIIer
3 inch pipping
moroso oiI pan pre tap
moroso vaIve cover
aII new seaIs and gaskets
acI race bearings
arp head studs
cometic head gasket
skunk 2 fueI raiI
skunk 2 pro intake manifoId
Last edited by spags930; 08-20-2009 at 10:44 PM.
#7
Junior Member
Join Date: Jan 2006
Location: On a island w/ only a bridge to leave it, U.S.A
Posts: 457
Likes: 0
Received 0 Likes
on
0 Posts
Re: compression ration question on what i shouId use
9.0.1, I'm running the same engine as you still get good low end when not in boost. I am using CP pistons/eagle rods.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
Dave_Dc2
All Motor / Naturally Aspirated
2
10-16-2008 10:56 PM