B16_sol

so i jus did a rebuild on my b16 and right when finishing we tried to start it, at first it wouldnt crank then we traced all tha wires for tha starter and tha ground was all nasty, so we fixed it and got it cranking. after that we jus never got spark to tha plugs, pulled tha dizzy apart and all parts had power and it was a very clean dizzy, then i checked to see what codes it was tossing at it gave me a #15 ignition out put signal. we checked all tha wires for tha dizzy and everything was good and thats as far as i am now so i dont know whats goin on with it. does anyone what this problem comes from???

B16_sol

bump

B16_sol

B16_sol

i jus bought a new dizzy and still nuffin

rasinhell

check the timing because this sounds all too familiar. same exact thing was happening to me but my timing was way off. prrs like a kitten now

B16_sol

well i tried a new ecu and nuthin checked all wires to tha harness of tha dizzy and all wires get voltage

rasinhell

make sure the crank thingy is timed correctly cuz that is the reason why my car wouldn't start.

Turbo_Mike

Did you have the motor out?

HybridVisions

Take all your wiring out and do it all over again...make sure distributor is set right.

HybridVisions

Oh yeah..check for fuel.....see if fuel pump even comes on..if it does..check fuel lines.

Turbo_Mike

Check your grounds, especially your thermostat!!11

Donkey85

yes, that is a very important ground and vital to not allowing the rig to start

B16_sol

it turned out to b a dead wire in tha harness runs like a beaut

B16_sol

thx for tha help ^_^