Bumpy idle after d16y8 swap complete , into 94 CX
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2003
Location: In my own world
Posts: 264
Likes: 0
Received 0 Likes
on
0 Posts
Bumpy idle after d16y8 swap complete , into 94 CX
I put a complete 00 EX motor into my 94 CX hatch . It starts fine and quick with no problems .. While its running , it has a bumpy idle even when I rev it up ...
This was my 1st Y8 manifold conversion into a OBD1 car . I left the EVAC ( the one on the fuel rail ) with nothing connected . I ran my old evac from the Z6 manifold and connected it to the vacum line behind the manifold .
The IAT , I extended the wires and stuck a hole into the rubber tube on my intake ( I used the IAT off the Z6 manifold )
There is no CEL at all so , I don't know what it could be .. anyone have any ideas ?
This was my 1st Y8 manifold conversion into a OBD1 car . I left the EVAC ( the one on the fuel rail ) with nothing connected . I ran my old evac from the Z6 manifold and connected it to the vacum line behind the manifold .
The IAT , I extended the wires and stuck a hole into the rubber tube on my intake ( I used the IAT off the Z6 manifold )
There is no CEL at all so , I don't know what it could be .. anyone have any ideas ?
Thread
Thread Starter
Forum
Replies
Last Post
rhdekhatchie
Honda Civic / Del Sol (1992 - 2000)
6
03-04-2008 08:56 AM
hybrid22
Honda Civic / Del Sol (1992 - 2000)
7
06-19-2004 11:22 AM