b16 sleeved 85mm bore + type r crank and rods = high reving 2L engine?
#1
Thread Starter
Join Date: Dec 2004
Location: Disney Land, CA
Posts: 297
Likes: 0
Received 0 Likes
on
0 Posts
b16 sleeved 85mm bore + type r crank and rods = high reving 2L engine?
i calculated that a sleeved b16 block with a 85mm bore with a type r crank would equal to 1979cc (2L)
so my question is. by keeping the type r crank and rods, the 2L b16 engine would still be able to rev up to 8500rpm. is this correct? the r/s ratio is still the same just bigger displacement.
dont ask why not just sleeve the b18c block. again its for my project for the "riced sleeper"
type r head of course
Modified by KockAsian at 9:20 AM 12/25/2004
so my question is. by keeping the type r crank and rods, the 2L b16 engine would still be able to rev up to 8500rpm. is this correct? the r/s ratio is still the same just bigger displacement.
dont ask why not just sleeve the b18c block. again its for my project for the "riced sleeper"
type r head of course
Modified by KockAsian at 9:20 AM 12/25/2004
Thread
Thread Starter
Forum
Replies
Last Post
Rice Is Best
Acura Integra Type-R
13
04-01-2012 06:54 PM
vtec8200
All Motor / Naturally Aspirated
11
06-13-2011 10:04 AM
weiRtech
All Motor / Naturally Aspirated
5
08-24-2006 11:00 AM