B Series measurement needed! H-T help an old timer out.
#1
Honda-Tech Member
Thread Starter
B Series measurement needed! H-T help an old timer out.
Hey.
Long time member here. I need help from someone with a B series laying around.
I need the measurement from:
- the left side of the tab in the picture, to the edge of the block (the green line).
- the left side of the tab in the picture, to the center of the A/C belt grooves on the crank pulley. As close as you can figure, i don't need super accurate, but as close as you can get!
Picture included.
Cheers from Canada.
Long time member here. I need help from someone with a B series laying around.
I need the measurement from:
- the left side of the tab in the picture, to the edge of the block (the green line).
- the left side of the tab in the picture, to the center of the A/C belt grooves on the crank pulley. As close as you can figure, i don't need super accurate, but as close as you can get!
Picture included.
Cheers from Canada.
#2
Fish Twig
Join Date: Nov 2005
Location: Still hunting that foo up there
Posts: 15,555
Received 309 Likes
on
285 Posts
Re: B Series measurement needed! H-T help an old timer out.
I see the green line, but I don't see the tab...
Hey.
Long time member here. I need help from someone with a B series laying around.
I need the measurement from:
- the left side of the tab in the picture, to the edge of the block (the green line).
- the left side of the tab in the picture, to the center of the A/C belt grooves on the crank pulley. As close as you can figure, i don't need super accurate, but as close as you can get!
Picture included.
Cheers from Canada.
Long time member here. I need help from someone with a B series laying around.
I need the measurement from:
- the left side of the tab in the picture, to the edge of the block (the green line).
- the left side of the tab in the picture, to the center of the A/C belt grooves on the crank pulley. As close as you can figure, i don't need super accurate, but as close as you can get!
Picture included.
Cheers from Canada.
Thread
Thread Starter
Forum
Replies
Last Post
Andrew Vang
Engine Machining & Assembly
1
11-19-2018 12:46 PM