04 v6 automatic - replacing ABS module / hydraulic unit - how to?
#1
Honda-Tech Member
Thread Starter
Join Date: Aug 2007
Location: Brampton, ON, CA
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
04 v6 automatic - replacing ABS module / hydraulic unit - how to?
My 2004 Accord V6 Automatic Coupe with 230k km /142k miles has a tendency to throw the hazard / TCS / engine warning lamps after a long drive (drives beyond 500km / 310 miles). The car then goes into a dangerous limp-mode which cuts power and causes the vehicle to act jerky.
I replaced the ABS wheel sensors but the issue persists.
I am thinking it is the ABS computer / module / hydraulic unit.
Has anyone replaced this unit before? How difficult is the replacement? Any tips or guides? Any re-programmed required by the dealership?
I replaced the ABS wheel sensors but the issue persists.
I am thinking it is the ABS computer / module / hydraulic unit.
Has anyone replaced this unit before? How difficult is the replacement? Any tips or guides? Any re-programmed required by the dealership?
Thread
Thread Starter
Forum
Replies
Last Post
Adverse_Martyr
Honda Accord & Crosstour (2003 - 2012)
1
08-03-2016 07:46 PM