Crankshaft pulley hitting timing belt
#1
Crankshaft pulley hitting timing belt
Well I just changed the timing belt in my wifes 94 accord LX and noticed then that the drive belt and crankshaft pully had rubbed into the timing belt cover and now the new belt is loose and I beleive that is the reason. Has anyone ever experienced this before?
#2
Honda-Tech Member
Re: Crankshaft pulley hitting timing belt
pull it appart and double check everything. make sure you put everything back where it's supposed to go and have everything tight. if it's not done right you could end up scrapping the engine.
#3
Honda-Tech Member
Re: Crankshaft pulley hitting timing belt
u probaly installed somehting wrong, mine rubs the plastic peices alot, now the plastic is melted off so it doesnt rub
#5
Re: Crankshaft pulley hitting timing belt
When I first pulled it apart I noticed that it had been ate completely through the plastic. I just didnt think that it would actually rub the belt. timing cover is completely on at the bottom.
#6
Re: Crankshaft pulley hitting timing belt
i have had this happen on my old 98 accord pully bolt just came loose and it messed up inside the pulley where the key goes. Got a new pulley and i had no more problems. Be sure to use locktite thread locker on the bolt or this will happen again. And if it has rubbed the timing belt change it. Rather be safe than sorry!!!
#7
Re: Crankshaft pulley hitting timing belt
i have had this happen on my old 98 accord pully bolt just came loose and it messed up inside the pulley where the key goes. Got a new pulley and i had no more problems. Be sure to use locktite thread locker on the bolt or this will happen again. And if it has rubbed the timing belt change it. Rather be safe than sorry!!!
Thread
Thread Starter
Forum
Replies
Last Post
pmgriphone
Honda Civic / Del Sol (1992 - 2000)
19
09-04-2015 08:11 PM
Tippyman
Tech / Misc
2
02-18-2006 09:04 AM