where to/who to go through for GE sleeving
#1
Member
Thread Starter
Join Date: Oct 2002
Location: Bloomington, IN
Posts: 1,612
Likes: 0
Received 0 Likes
on
0 Posts
where to/who to go through for GE sleeving
right now im trying to decide on which setup i want to go with, h22 turbo, or b20vtec turbo....so im adding up all the cost to get the stuff i want done and see what the price diff. between the two setups is...
i am going to get the motor fully built and plan on running GE sleeves, but i was wondering if i have to go directly through GE to get the work done, or if i can go through another place that i could get the prices cheaper?...i would also rather have the motor built, i.e. rods, pistons, bearing, ect. all installed and ready to go once i receive it...i tried emailing GE but havent heard back yet (they prolly get a million emails a day)
i keep reading about past group buys but it doesnt seem there is going to be anymore so who or where should i go through to get the best work done at the best price? any advice would be appreciated, thanx
i am going to get the motor fully built and plan on running GE sleeves, but i was wondering if i have to go directly through GE to get the work done, or if i can go through another place that i could get the prices cheaper?...i would also rather have the motor built, i.e. rods, pistons, bearing, ect. all installed and ready to go once i receive it...i tried emailing GE but havent heard back yet (they prolly get a million emails a day)
i keep reading about past group buys but it doesnt seem there is going to be anymore so who or where should i go through to get the best work done at the best price? any advice would be appreciated, thanx
#4
Junior Member
Join Date: Apr 2002
Location: poughkeepsie, ny, u.s
Posts: 89
Likes: 0
Received 0 Likes
on
0 Posts
Re: where to/who to go through for GE sleeving (Mase)
yeah i am going to go all out this winter on my hatch i want to know who would be the best to go with for a total built bottom end package i was looking at import builders to do the work but i want to see what you guys think 1st.
Thread
Thread Starter
Forum
Replies
Last Post
gsracer170
Forced Induction
53
09-10-2009 10:42 AM