wastegate elbow clearance.
#1
Honda-Tech Member
Thread Starter
wastegate elbow clearance.
I'm running a tial 38mm wastegate on a revhard cast manifold...I have a siebon cf hood which is fresh out of the box so I would like to avoid cracking it. Anyone have a similar setup who would tell me a good elbow to buy. I need a lot of clearance...not only does the hood hit the top banjo on the wastegate but it hits the top of the wastegate itself when that banjo is removed. Any ideas?
Thread
Thread Starter
Forum
Replies
Last Post
BoostedGSRBubble
Forced Induction
13
03-05-2003 07:45 PM