USING Aluminum Soldering Rods to join intercooler entanks to the core??
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2002
Location: I am Paypal Verified
Posts: 2,866
Likes: 0
Received 0 Likes
on
0 Posts
USING Aluminum Soldering Rods to join intercooler entanks to the core??
is it feasable to use these bensomatic aluminum soldering rods that u can buy at Home depot to solder/braze custom aluminum endtanks to an intercooler core?? i was thinking about doing this, but i just wanted some opinion on the subject b4 i actually do it and chop apart my existing intercoolers.. would the joints hold up to the pressures of boost, (in the neighborhood of 12 lbs).. i'm pretty sure it beats the JBweld route that was brought up on the board a few weeks ago..
Thread
Thread Starter
Forum
Replies
Last Post