Daemione

I'm curious - how do the Greddy sizes (16g, 18g, etc.) compare to the standard T3, T4 sizes that garrett uses?

Thanks.

rtype11

you are not comparing apples with apples here - this is not how you check sizes.

Daemione

Thank you for your informative post.

I'm just looking for the basics here (e.g. is a 16g bigger or smaller than a T3?).

Nothing fancy.

If I were deciding on what to use, believe me, I'd be looking at compressor maps & doing some calculations. But I'm just looking for rough guesstimates.

DLB1994

i think the 16g is like the same as the t28 smaller then the t3 and the 18g is like a t3 and a 20g is like a t4

Daemione

. . . thanks . . . .

TypeC

that was the biggest load(no offense).

A t3 should be smaller than a 16G. I don't know, but a comparison (with Mitsu charges too) would be helpful. I think all his is asking for is a X>Y>Z>B type thing.
-C


[Modified by TypeC, 4:25 PM 10/18/2001]

DLB1994

i said i think but on the compressor maps on them one's they look close to the same size

TypeC

I meant it was hard to understand what you were saying. Where is a good URL for compressor maps?

-C

DLB1994

this is the one on garrett http://www.turbocharged.com/main.htm

i got to find where i seen the mitsubishi and greddy maps at