Tuned my set up today. Results are in!
#1
Honda-Tech Member
Thread Starter
Join Date: Jul 2004
Location: southwest, PA, USA
Posts: 3,054
Likes: 0
Received 0 Likes
on
0 Posts
Tuned my set up today. Results are in!
Here is the set up:
RLD fab mani
3" DP and exhaust
T3/60-1 Ball bearing with S comp cover
Tual 38mm gate
Golden eagle 84mm block
CP pistons
Manley rods
B16 head ported
skunk2 valvetrain
ITR cams, IM and TB
255lph pump
1000cc precision injectors
AEM FPR
3bar
Tuned on S300 By Joe at Pittsburgh Performance
14psi and pump gas tune it did 401whp
112 Octane tune was 583whp 379TQ at a peak of 32psi falling to 29-30psi at redline. It was also spinning the tires on the dyno and the clutch began to slip the last few pulls
Ill try to upload my dynosheets tomorrow if I can get my scanner to work.
RLD fab mani
3" DP and exhaust
T3/60-1 Ball bearing with S comp cover
Tual 38mm gate
Golden eagle 84mm block
CP pistons
Manley rods
B16 head ported
skunk2 valvetrain
ITR cams, IM and TB
255lph pump
1000cc precision injectors
AEM FPR
3bar
Tuned on S300 By Joe at Pittsburgh Performance
14psi and pump gas tune it did 401whp
112 Octane tune was 583whp 379TQ at a peak of 32psi falling to 29-30psi at redline. It was also spinning the tires on the dyno and the clutch began to slip the last few pulls
Ill try to upload my dynosheets tomorrow if I can get my scanner to work.
#3
Honda-Tech Member
Thread Starter
Join Date: Jul 2004
Location: southwest, PA, USA
Posts: 3,054
Likes: 0
Received 0 Likes
on
0 Posts
Re: Tuned my set up today. Results are in!
I actually didnt get that sheet printed but I think it was about 5000-5500 on the 400whp pull
Trending Topics
#8
Honda-Tech Member
Thread Starter
Join Date: Jul 2004
Location: southwest, PA, USA
Posts: 3,054
Likes: 0
Received 0 Likes
on
0 Posts
Re: Tuned my set up today. Results are in!
Yeah. its a T3/60-1 with a stage 3 exhaust wheel and small .63 hotside. It is out of juice for sure. Also remember the tires and clutch were spinning on the dyno at 583whp so I dont know the number it would have made had it been a clean pull
Thread
Thread Starter
Forum
Replies
Last Post
SpeedingHatch
Forced Induction
34
06-05-2006 12:43 PM