T4 manifold fitment ? (using t3/t4 turbo) w/ making a flange
#1
Junior Member
Thread Starter
Join Date: Apr 2005
Location: blacksburg, va, usa
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
T4 manifold fitment ? (using t3/t4 turbo) w/ making a flange
Could I use a T4 manifold that I can get a killer deal on w/ a T3/t4 turbo if I machine a flange that would go between the turbo and manifold to make them fit basically have the flange match up with the set of bolt holes on the exhaust mani and then drill and tapp another set of holes smaller to fit to the t3/ t4 turbo part.
Would this work and are there any cons to doing this.
Would this work and are there any cons to doing this.
#4
Junior Member
Join Date: Sep 2003
Location: NorCal, CA
Posts: 536
Likes: 0
Received 0 Likes
on
0 Posts
Re: T4 manifold fitment ? (using t3/t4 turbo) w/ making a flange (spoolingb20)
You can make a flange or buy one that adapts the t3 turbo to a t4 flange. The only problem is, if it's a ram horn manifold, the turbo would probably hang too low for the oil return.
#5
Junior Member
Thread Starter
Join Date: Apr 2005
Location: blacksburg, va, usa
Posts: 548
Likes: 0
Received 0 Likes
on
0 Posts
Re: T4 manifold fitment ? (turtle-eg)
well if it is just a cast mani; to be exact its the rev hard mani, you think that it will sit high enough for the oil lines,
Thread
Thread Starter
Forum
Replies
Last Post