T3 Turbo Flange Porting???
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2008
Location: Hickory,nc
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
T3 Turbo Flange Porting???
Hi,
I have a Garrett T3 50 trim turbo and a SPA rep cast top mount manifold from ebay. The turbine port is too small. From the pic below, the Turbine width is 1/8" smaller and the Length is 1/4" smaller. I dont know if that's usually normal having to port the the turbine housing? I'm not sure if I really want to port the Turbine larger as it may too big of a enlargement or cause cracking?
Top= Turbine
Bottom= Manifold
Turbine
I have a Garrett T3 50 trim turbo and a SPA rep cast top mount manifold from ebay. The turbine port is too small. From the pic below, the Turbine width is 1/8" smaller and the Length is 1/4" smaller. I dont know if that's usually normal having to port the the turbine housing? I'm not sure if I really want to port the Turbine larger as it may too big of a enlargement or cause cracking?
Top= Turbine
Bottom= Manifold
Turbine
#2
Honda-Tech Member
Re: T3 Turbo Flange Porting???
That's A lot of material, from past experience I would open it up at and angle and try to keep it as smooth as possible, seems like a lot of material in the last picture, best of luck ive seen it done before with 0 issues
#3
Honda-Tech Member
Thread Starter
Join Date: Jan 2008
Location: Hickory,nc
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
Re: T3 Turbo Flange Porting???
Feel like it's too excessive. I'm assuming sometimes ppl do have to port it out some, but not this much. First time going boost so I'm unsure.
Thread
Thread Starter
Forum
Replies
Last Post