t3/t04e ball-bearing turbo
#1
Honda-Tech Member
Thread Starter
Join Date: Aug 2001
Location: Miami, FL, USA
Posts: 1,564
Likes: 0
Received 0 Likes
on
0 Posts
t3/t04e ball-bearing turbo
I have a 50 trim t3/to4e on my y8 and I was looking at the ball-bearing upgrade. Has run this on their setup before?
I'm think I'm going to get this upgrade in the future. I know it uses oil and water cooling. I already have the oil lines obviously, but how do I run the water lines.
GT turbo guys chime in!!
http://www.atpturbo.com/Mercha...e=GTB
I'm think I'm going to get this upgrade in the future. I know it uses oil and water cooling. I already have the oil lines obviously, but how do I run the water lines.
GT turbo guys chime in!!
http://www.atpturbo.com/Mercha...e=GTB
#3
Honda-Tech Member
Thread Starter
Join Date: Aug 2001
Location: Miami, FL, USA
Posts: 1,564
Likes: 0
Received 0 Likes
on
0 Posts
Re: t3/t04e ball-bearing turbo (Synapse Motorsport)
well then I'll have to get a new manifold and charge piping
I really just want to see how the 50 trim would react to being ball bearing.
I really just want to see how the 50 trim would react to being ball bearing.
Trending Topics
#8
Member
Join Date: Aug 2003
Location: Atlanta, GA, USA
Posts: 2,234
Likes: 0
Received 0 Likes
on
0 Posts
Re: t3/t04e ball-bearing turbo (willyboyK20)
For the water lines I used the hose that was going to my TB(the line used to warm up the TB) from the Water neck and then the other line that was going from the water pipe to the TB to the other line on the Turbo.
Works good and at the same time it gets rid of some heat that would have gone onto your TB/manifold.
Works good and at the same time it gets rid of some heat that would have gone onto your TB/manifold.
Thread
Thread Starter
Forum
Replies
Last Post
DrivinVtec
Forced Induction
18
06-24-2006 08:19 PM
PeakBoost
Forced Induction
31
12-27-2005 10:10 PM