Set up "race" pcv system and car wants to die after revving, anyone else?
#1
Thread Starter
Join Date: Nov 2001
Location: Where free thought comes to die, US
Posts: 678
Likes: 0
Received 0 Likes
on
0 Posts
Set up "race" pcv system and car wants to die after revving, anyone else?
Normally w/ the hondata ill get that low idle bounce but not like this. The car comes as close as possible to dying and then bounces back. When i say race pcv setup, i mean breather on valve cover, hollowed out pvc valve dumping to ground and covered intake manifold nipple. Is this common?
#3
Thread Starter
Join Date: Nov 2001
Location: Where free thought comes to die, US
Posts: 678
Likes: 0
Received 0 Likes
on
0 Posts
Re: Set up "race" pcv system and car wants to die after revving, anyone else? (guido-kp)
No, i even tried covering it w/ my finger. Could it be it was tuned w/ a stock pcv system and the fuel necessary is slightly different?
#4
Join Date: Sep 2002
Location: Where Geos Go Fast, 95355
Posts: 1,969
Likes: 0
Received 0 Likes
on
0 Posts
Re: Set up "race" pcv system and car wants to die after revving, anyone else? (BoostedGSRBubble)
at idle, the engine is pulling in crankcase vapors/air... it may be possible that the IAC is having a hard time trying to adjust to the less-than normal air bypassing the throttle plate.
Thread
Thread Starter
Forum
Replies
Last Post
the.hamburglar
Acura Integra
3
01-26-2009 05:14 AM
the.hamburglar
Forced Induction
11
04-23-2007 08:34 PM
marcin
All Motor / Naturally Aspirated
20
11-20-2005 10:55 PM