lbz34

Last night me and my friends installed a custom 2 1/2" exhaust in my gs-r. No cat 2 1/2" flexpipe and all mandrels. Man exhaust really sucks to make. Cut each bend then trim to fit fairly even then weld. The exhaust goes into a 3" magnaflow muffler. very deep tone, some slight buzzing at 3500-4500 rpm. Very loud inside the car, although i do not have a tip on it as of yet. all the sound is going inside my rear bumper and drilling my brain!! Need to get a tip on this thing. May sell the magnaflow and go with something a little quiter. Well see after the tip and turbo go on next week.


[Modified by lbz34, 1:22 PM 4/5/2002]

zojirushi

the turbo might quiet down the exhaust tone a little bit

falcongsr

i am going with the same setup with a turbo. i think it will be much quieter. exactly which magnaflow muffler did you get?

Joe

rioninja

Putting the turbo will drop the noise level in half, and most of the time will get rid of the buzziness. I say stick with it for now, it will probably come out sounding decent

b18bvudoo

whatever you do, dont get a dynomax.....loud.

paulzy

iTrader: (1)

dynomax's are not loud....not from my experiences....with the super turbo and the ultra flo

lbz34

i dont remember the part number but the mufler is a magnaflow, alimunized 3" in/out. It is a LOT smaller than the stock muffler. I had to put it at a funny angle to make it come out at the right spot being a center in/out muffler. but i did get it for $65 so it was a good deal. I am sure it sill be much better with a 3" in to two 2.5" outlets and the turbo. jsut have to wait for road race engineering to ship the tip again.