oil feed size on turbo itself
#1
Honda-Tech Member
Thread Starter
Join Date: Dec 2005
Location: Fairbanks, Alaska
Posts: 725
Likes: 0
Received 0 Likes
on
0 Posts
oil feed size on turbo itself
got some leaks on top of the turbo. the main feed line. just need to know what size. i beleive 1/2 NBST.
i teflon tape the old exsiting feed and it held for about a week until the turbo temps melted the teflon. should i use high temp silicon?
its not the normal male nipple that you use a gasket for. its somethign just threaded into the top.
tried searching but everything was coming up on block fittings. a FAQ pictures are long outdated not showing much.
just trying to save some time by ordering the part i need instead of disconnecting everything...call girlfriend to take me to hardware store, find out store doesnt have or carry it...drive to another store.. etc...
i teflon tape the old exsiting feed and it held for about a week until the turbo temps melted the teflon. should i use high temp silicon?
its not the normal male nipple that you use a gasket for. its somethign just threaded into the top.
tried searching but everything was coming up on block fittings. a FAQ pictures are long outdated not showing much.
just trying to save some time by ordering the part i need instead of disconnecting everything...call girlfriend to take me to hardware store, find out store doesnt have or carry it...drive to another store.. etc...
Thread
Thread Starter
Forum
Replies
Last Post
TheIntegraGuy
Forced Induction
3
08-21-2005 11:01 AM