building b18a1 block,do i need sleeves?
#1
Thread Starter
Join Date: Jun 2004
Location: Houston, Tx, usa
Posts: 985
Likes: 0
Received 0 Likes
on
0 Posts
building b18a1 block,do i need sleeves?
i have a 92 integra and im going to boost it,so im going to build the block. these are some of the parts im putting in.
eagle rods
ge block guard
arp headbolts
forged pistons (dont know what kind to use or what comp.)
thats all for the bottom end. im looking to get 350whp out of it.its my only car so its driven an average of about 300 miles a week. to start of i was thinking of like 9 psi and then go all out,till i reach the 350whp mark.do yall think i should sleeve the block? and also what kind of pistons should i buy for what im looking for? let me know what yall think.thanx
eagle rods
ge block guard
arp headbolts
forged pistons (dont know what kind to use or what comp.)
thats all for the bottom end. im looking to get 350whp out of it.its my only car so its driven an average of about 300 miles a week. to start of i was thinking of like 9 psi and then go all out,till i reach the 350whp mark.do yall think i should sleeve the block? and also what kind of pistons should i buy for what im looking for? let me know what yall think.thanx
Thread
Thread Starter
Forum
Replies
Last Post
MidShipCivic
Forced Induction
10
02-09-2005 11:27 AM