Wiring ECB-1 flex fuel to S300 V3
#1
Wiring ECB-1 flex fuel to S300 V3
Hello,
I was wondering if anyone could advise me on how to wire and get the S300 to read flex fuel content using an Innovative motorsports ECB-1 gauge. Right now I have the gauge operating and reading correct. I have it wired to pin D10 at the ECU (obd 1). My ELD on the S300 is showing .86 volts. The 0-5v wire coming off the back of the gauge is showing the same .86 volts. The gauge is showing 8.6% ethanol. However the flex fuel sensor on the "sensors" tab E% is showing 0. What could I be doing wrong here to get no reading on the S300?
I was wondering if anyone could advise me on how to wire and get the S300 to read flex fuel content using an Innovative motorsports ECB-1 gauge. Right now I have the gauge operating and reading correct. I have it wired to pin D10 at the ECU (obd 1). My ELD on the S300 is showing .86 volts. The 0-5v wire coming off the back of the gauge is showing the same .86 volts. The gauge is showing 8.6% ethanol. However the flex fuel sensor on the "sensors" tab E% is showing 0. What could I be doing wrong here to get no reading on the S300?
Thread
Thread Starter
Forum
Replies
Last Post