Failed leakdown after new gasket and resurface
#1
Failed leakdown after new gasket and resurface
My d16y8 just recieved a new head gasket and resurface. Problem is when i pressurize a cylinder i get air in the coolant. Im almost convinced that block must be resurfaced. Any input is welcomed.
Do i need to dissassemble the block to have it decked?
should i resurface the head again? 1,000 miles since done last.
Do i need to dissassemble the block to have it decked?
should i resurface the head again? 1,000 miles since done last.
#2
Honda-Tech Member
Re: Failed leakdown after new gasket and resurface
block may be warped, and yes it needs to be completely torn down to resurface.
could have a cracked cylinder too. or the head may be cracked
could have a cracked cylinder too. or the head may be cracked
#3
#4
Re: Failed leakdown after new gasket and resurface
Have you heat cycled the head gasket? Or is this before running the engine even once after the install?
#5
#6
Re: Failed leakdown after new gasket and resurface
Thread
Thread Starter
Forum
Replies
Last Post
MrCivic242
Honda Civic / Del Sol (1992 - 2000)
8
03-05-2014 02:04 PM
arielb1
Honda Civic / Del Sol (1992 - 2000)
14
11-03-2004 07:14 AM