Boot lid wanted 65 S600, Michelago NSW
#1
Honda-Tech Member
Thread Starter
Join Date: Apr 2014
Location: Michelago New South Wales
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Boot lid wanted 65 S600, Michelago NSW
Hi all, my post here so first of all, thanks for including me in your sickness....I mean S600 bug.
Unfortunately my boot lid is looking like more like a sheet of corrugated iron than a boot lid, and a little rusty as well, so does anyone here have a good one that they would be prepared to sell or swap for something I have that they may need for their S600?
I have a fair few carbies etc (no full sets unless there is enough to make a full set but I doubt it) spare tail shaft, inlet manifolds etc. If there is something you want in exchange just ask and I will have a look to see if I have it.
Regards, Tony Brown
I should mention that it is a roadster!
Unfortunately my boot lid is looking like more like a sheet of corrugated iron than a boot lid, and a little rusty as well, so does anyone here have a good one that they would be prepared to sell or swap for something I have that they may need for their S600?
I have a fair few carbies etc (no full sets unless there is enough to make a full set but I doubt it) spare tail shaft, inlet manifolds etc. If there is something you want in exchange just ask and I will have a look to see if I have it.
Regards, Tony Brown
I should mention that it is a roadster!
#2
Re: Boot lid wanted 65 S600, Michelago NSW
There is a mob in Melbourne who make fiberglass copies. They are quite good. I currently cannot remember the name of the company. But maybe an internet search could help.
#3
Honda-Tech Member
Thread Starter
Join Date: Apr 2014
Location: Michelago New South Wales
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Re: Boot lid wanted 65 S600, Michelago NSW
Thanks guys, I know its a long shot but if I can, I would prefer an original steel one if possible
That may not be feasible, in which case the fibreglass one may be the best solution.
That may not be feasible, in which case the fibreglass one may be the best solution.
#5
Honda-Tech Member
Re: Boot lid wanted 65 S600, Michelago NSW
http://page13.auctions.yahoo.co.jp/j...ion/r113884962.
Neko.
Trending Topics
#9
Honda-Tech Member
Thread Starter
Join Date: Apr 2014
Location: Michelago New South Wales
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Re: Boot lid wanted 65 S600, Michelago NSW
Well that certainly was cheap, my greatest fear in buying panels is the risk of damage in transit, more at our end than anywhere, where fragile means "throw underarm".
Has anyone else had success/failure with buying panels from overseas?
Has anyone else had success/failure with buying panels from overseas?
Thread
Thread Starter
Forum
Replies
Last Post
hondaowner
Honda Civic / Del Sol (1992 - 2000)
4
08-05-2004 12:38 PM