Keeping 4x100 on B series.
#1
Honda-Tech Member
Thread Starter
Keeping 4x100 on B series.
Ideas.....Im all ears on this. I have Volk Rays g-games 17x7 4x100. I wont manage to buy new set of rays...
What could make it work?
What could make it work?
#5
Re: Keeping 4x100 on B series.
lol has the skill set to convert a car to awd but is dumbfounded and completely un-aware of custom redrilled hubs or hub adaptors ... totally believable .... and if the cost of some older china rep wheels (those arent anything special or expensive bud) is even a drop of a expense vs cost of correctly fabricating and converting your car with all the misc odds and ends stuff you have to buy then you are doing it wrong
#7
Honda-Tech Member
Re: Keeping 4x100 on B series.
You can use any sort of standard 4 lug front hubs, and rt4wd rear trailing arms spliced or I've heard people also use insight front hubs retro fit to rear trailing arms. There's a guy who makes a plate kit for it my buddy was telling me about but it's slipping my mind right now.
The following users liked this post:
Trending Topics
#9
Honda-Tech Member
Re: Keeping 4x100 on B series.
I used Integra axles. The right side axle has to be ground down a little so the c clip will go all the way in, maybe 1/8" off of it
#11
#13
Honda-Tech Member
Re: Keeping 4x100 on B series.
Base Model manual RSX axles work with the BAWD trans and retain the 32mm hubs. I run this setup in my car. swap the axles left to right and you will be fine. dont over think it
The following users liked this post:
Thread
Thread Starter
Forum
Replies
Last Post