miahallen.on.ln

Hey TSX fans,

I'm building a racing simulator and I bought an 04/05 TSX drivers seat to use for it (link to my build if you're curious). I have an aux 12V power supply to hook it up so I can make position adjustments, but I don't know what wires need to be hooked up.

I'm wondering if anyone can help me identify where I need to plug in my 12V & ground lines to make the seat movements function. Obvoiusly, I'm not concerned with the seatbelt sensor or the airbag, and I don't care about the seat heater either. Thanks

http://www.thewayiplay.com/mainforum...p?topic=2554.0

miahallen.on.ln

Here is a video showing where I am at with this project, any help would be appreciated

UTAH TSX

Here you go

UTAH TSX

and

miahallen.on.ln

Dude...sweet!!! But a little too slow. I ended up cutting out the control box

It turns out I was able to bypass the control board and wire my amp directly to the DPDT switch PCB in the side of the seat...





I started by probing all the contacts with the switches in all positions...



I don't have a clue how it worked from the factory, but when I wired an additional two ground wires to this board (into pins which were unused) I was able to get full functionality.



After getting that figured out I just needed to mount the new seat and wire it up to my rig.

Check my build log here for the final result.
http://www.gtplanet.net/forum/thread...3#post-8507004

robpp

looks good.

my bud Paul in the UK has a similar setup.

100 inch screen. he does all the F1 stuff.

pretty cool when you get the actuators moving LOL

GL

miahallen.on.ln

Thanks again robpp, it would have been nice to preserve the original control box for possible future resale....but I think I'll probably keep this seat for a while anyway :-)