EP3 Buddy Club Ball Joint fitment issue
#1
Honda-Tech Member
Thread Starter
Join Date: Jan 2005
Location: Philly
Posts: 1,501
Likes: 0
Received 0 Likes
on
0 Posts
EP3 Buddy Club Ball Joint fitment issue
I'm installing the ball joints but it appears the pass side had been replaced with a slightly larger ball joint by the previous owner. The BC one slides in with almost no effort. The driver's side fit just fine though.
I'm going to replace the knuckle, but while I wait for it to arrive(most likely the end of the week) can I run one extended ball joint and one normal length ball joint?
I'm going to replace the knuckle, but while I wait for it to arrive(most likely the end of the week) can I run one extended ball joint and one normal length ball joint?
Thread
Thread Starter
Forum
Replies
Last Post
GruvyTune
Tech / Misc
5
07-22-2002 10:01 AM