Stubby Gas Lens Torch Setup
#1
Honda-Tech Member
Thread Starter
Stubby Gas Lens Torch Setup
Im looking for parts to set up a wp9 and wp17/26 air cooled torches
with stubby gas lens and a champagne cup for each.
So far ive only come across tectorch for the wp17/26 parts.
Think i have the part numbers covered.
are there any other places i can get all i need ?
with stubby gas lens and a champagne cup for each.
So far ive only come across tectorch for the wp17/26 parts.
Think i have the part numbers covered.
are there any other places i can get all i need ?
#2
Honda-Tech Member
Join Date: Sep 2010
Location: Wisco
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
#3
Re: Stubby Gas Lens Torch Setup
Airgas local welding stores all across the country have Radnor parts that are private branded Weldcraft torch front end parts. They have WP9/20 standard gas lenses which take cups up to #8, and stubby large gas lens setups that will handle #12 (3/4") and #15 (15/16") cups. You can find these parts numbers on the Weldcraft manufacturers web site.
They are also much cheaper than the ebay / internet vendors.
They are also much cheaper than the ebay / internet vendors.
Last edited by Mr. Moose; 01-06-2012 at 04:03 PM.
#6
Re: Stubby Gas Lens Torch Setup
Make sure you get all the parts you'll need
a. stubby large gas lens
b. collet
c. cups in sizes you need, and
d. different insulator for the bigger cups, which sometimes gets forgotten
The pink cups are about $2.xx each, and thread on properly, as compared to the pyrex glass type cups that cost $$$ and fall off and break...
a. stubby large gas lens
b. collet
c. cups in sizes you need, and
d. different insulator for the bigger cups, which sometimes gets forgotten
The pink cups are about $2.xx each, and thread on properly, as compared to the pyrex glass type cups that cost $$$ and fall off and break...
Thread
Thread Starter
Forum
Replies
Last Post
RC000E
Welding / Fabrication
10
09-24-2006 06:45 AM
Jays91DXhatch
Welding / Fabrication
7
09-14-2005 01:41 PM