Boilermaker1

I need to make a custom one due to some space constraints.... vertical flow core, 18" long, 3" wide, end tanks will be kind of pancaked (1.5" tank for 2" inlet, 2" tank for 2.5" outlet w/ extensions hanging off the side of the tank so that the full diameter of the pipe is somewhat utilized....

Trying to order some stock to make the end tanks now, how thick is normal? .100 or .125? thicker?
Also how much of a PITA are these things to usually weld to the core? I'm not able to do it myself (don't know how to TIG), but I'd like to make all the parts and then take it to someone who can, just trying to figure out how selective I have to be. Should I just take it to a performance shop to be sure it gets done right and pay through the nose for the welding?
Is anyone here want to take up a little afternoon project for beer money?
Thanks for the help

9295EJ-t

iTrader: (1)

the end tanks on mine are 1/8" thick

.RTErnie

send it to me...I'll do it for ya.

I would allow more room for flow on the end of the tanks...and not squish them as you've shown in your drawing.

1/8" thickness max... i've seen ic tanks made from some pretty thin stuff before. I typically do 1/8" because its what i have lying around.

tony1

I wouldn't do any thinner than .125"

Boilermaker1

1/8 max and no less than 1/8.... sounds like 1/8 is the way to go then

And the goofy end tanks are because the IC can be no more than 9.5" top to bottom. I think I'm going to ditch the angles and just go with square tanks.

JDMCRX

iTrader: (2)

The end of the end tank is useless limited flow there make the end of the tank say .5" higher to allow some flow to reach the end plates