Trying to find 1/2" SS for flange
#1
Honda-Tech Member
Thread Starter
Join Date: Feb 2005
Location: Arden, NC, USA
Posts: 758
Likes: 0
Received 0 Likes
on
0 Posts
Trying to find 1/2" SS for flange
I'm trying to find some 304 stainless so I can make a decent downpipe flange.
I have some aluminum and stainless on hand and can cut to size if someone is willing to trade for a piece of 1/2" 304 stainless plate that I can get a couple flanges out of.
I have some aluminum and stainless on hand and can cut to size if someone is willing to trade for a piece of 1/2" 304 stainless plate that I can get a couple flanges out of.
#3
Trending Topics
#8
Honda-Tech Member
Thread Starter
Join Date: Feb 2005
Location: Arden, NC, USA
Posts: 758
Likes: 0
Received 0 Likes
on
0 Posts
Re: Trying to find 1/2" SS for flange (Adriano)
I was wanting a flange for the T3 Garrett downpipe with 2.5" hole and 3.5" diagonal hole spacing.
Ebay has a 12"x12" plate for $50, but I'm trying to get away from dumping more money in it.
Ebay has a 12"x12" plate for $50, but I'm trying to get away from dumping more money in it.
#10
Honda-Tech Member
Thread Starter
Join Date: Feb 2005
Location: Arden, NC, USA
Posts: 758
Likes: 0
Received 0 Likes
on
0 Posts
Re: Trying to find 1/2" SS for flange (Adriano)
I'm looking for stainless 7/16 to 1/2" thick. I haven't seen any yet with the size hole I need.
OBX makes some decent ones, but I haven't seen any with the 2.5" hole. I already have two flanges sitting on my desk that I can't use and was hoping to just find some material and make it myself now that I have a pattern to go by.
OBX makes some decent ones, but I haven't seen any with the 2.5" hole. I already have two flanges sitting on my desk that I can't use and was hoping to just find some material and make it myself now that I have a pattern to go by.
#11
Honda-Tech Member
Join Date: Sep 2002
Location: Vila Velha, Brasil
Posts: 1,666
Likes: 0
Received 0 Likes
on
0 Posts
Re: Trying to find 1/2" SS for flange (greasemonkee)
Are the bolt pattern different or the hole too small? If it's the hole being small, you can always port it out.
Adriano
Adriano
#13
Honda-Tech Member
Thread Starter
Join Date: Feb 2005
Location: Arden, NC, USA
Posts: 758
Likes: 0
Received 0 Likes
on
0 Posts
Re: Trying to find 1/2" SS for flange (greasemonkee)
Still looking for stainless plate.
Recently came across some aluminum round stock and pipe along with some 3" SS exh pipe.
Recently came across some aluminum round stock and pipe along with some 3" SS exh pipe.
Thread
Thread Starter
Forum
Replies
Last Post