K Series Clutch Case Swap

Reply Subscribe

Thread Tools

Search this Thread

06-23-2009, 04:35 PM

integra_gsr98

Honda-Tech Member

Thread Starter

Join Date: Jul 2001

Posts: 899

Likes: 0

Received 0 Likes on 0 Posts

K Series Clutch Case Swap

Finally getting started on my swap and when going to install the LSD realized that the motor mount holes on the clutch case were broken and that the threads were all jacked up. Can I order a new clutch case and just swap the internals over and use new bearings? Or will I have to disassemble the entire trans and re-shim everything?

Here are some pics...

High Res Link: http://www.imperial.org/~nick/gsr/pr...009/trans1.jpg

High Res Link: http://www.imperial.org/~nick/gsr/pr...009/trans2.jpg

High Res Link: http://www.imperial.org/~nick/gsr/pr...009/trans3.jpg

Reply Like

06-23-2009, 05:14 PM

Honda Bull

Honda-Tech Member

Join Date: Nov 2004

Location: 40.201N, 77.189W, PA

Posts: 4,738

Likes: 0

Received 7 Likes on 4 Posts

Re: K Series Clutch Case Swap

The correct way to go about making a change like this (case or mainshaft swap) is to check the mainshaft and differential bearing clearances. If you have a HELMS manual, you should be fine. It's only a bit extra work. And you'll need to disassemble everything for the most part to do the LSD anyhow. :p

Good luck, man!