RyanStevenPhillips

alright guys, i just installed a jdm h22 in my prelude. everything is fine, except i cant get pressure in my clutch pedal no matter what i do. ive tried bleeding it multiple times, probably pumping the clutch pedal 1000x. the fluid will get all the way to the slave cylinder, but will never go through it. literally, if you pump the pedal without the slave there it will come out in a full spout, but it just wont enter the slave.(ive tried 2 different slave cylinders. is this just the kind of thing where you just have to keep doing it until it finally gets to the slave, or am i doing something wrong???

process: tighten down slave bolt, pump clutch pedal multiple times while adding brake fluid to master cylinder, hold clutch to floor, loosen slave bolt to let air out, repeat.

thanks

RyanStevenPhillips

I tried doing it again... still nothing. Any ideas?!?!

RyanStevenPhillips

Never mind. It just decided to go on the 8th attempt when I was trying it by myself.

crx-b18c

pull out all the way bleeding screw and cleaning very good and then try again good luck