Riverada9

Well as you can see up there my Vtec will not engage at all and b16a with not vtec is an embarrassment I got CEL Codes for 07,21 tps and vtec solenoid valve. And 21 electrical load detector... I'm not sure why is doing this my wiring and oil pressure is good I let it warm up and everything yet nothing is it a bad solenoid? Or what can it be? Can it be the tps? Also have another problem where I press on the brakes and my cluster, fog, side markers light up and my clock dims. Also when I have my lights on my car idles poorly. Can it be a bad ground? Where can I find this ground? Any help would be really appreciated thanks. I looked everywhere and no answers PLEASE NEED HELP WITH THIS!

grumblemarc

iTrader: (4)

Help? Fix the things causing the codes.

Sounds like you did a **** poor job with that swap. YOu have bigger things to worry about rather than stupid VTEC.

Riverada9

@grumblemarc I only have code 21 and 20 and I would be thinking 20 might be my alrernator cause it was going bad on me but I replaced it and yet it's there so that wasn't my problem and 21 is the vtec solenoid which Is why I think it's not working but my vtec solenoid works cause I've tested it on my friends car and it works so I'm not sure. Also I would be thinking why my fogs turn on when i press on the brakes is cause of grounds? I'm just trying to get everything functioning properly thanks for replying

JPhilBradley

Check for a bad ground

m4xwellmurd3r

Da9s dont have an ELD thats why you're getting a code for it. You have to have that deleted from the ecu to make that code go away. Fix the codes and youre other wiring issues.

hondawhiz

Get a chipped ecu