kte324

iTrader: (2)

I bought a 00' Si with a jdm b16a. I was in the process of replacing the front seals when the ones I bought (for a b16a2) did not fit. On the cam seal the overall outside diameter was to big. I have done about a million timing belts on about every different honda motor and have never ran into this problem.

Can someone please give me the part number for the correct ones or tell me where I can go to get them?

mouab18c1

iTrader: (5)

Did you get the right part?

kte324

iTrader: (2)

Yep, I've ordered these parts plenty of times oem and aftermarket. They're just different from the ones that came out.

mouab18c1

iTrader: (5)

Hmm interesting

This might give you an idea

http://hondaswap.com/general-tech-ma...ft-seal-60844/

Kova23

91213-PR3-004 is camshaft seal, the size is 29X43X8 mm
91212-PR4-A01 is front crankshaft seal, the size is 38X50X7.4 mm.

kte324

iTrader: (2)

Didn't give me much.

These are part numbers for B16A2, which is clearly different than the B16A I have.

Both Camshaft and Crankshaft seals have bigger outside diameter than the ones for B16A2. I will post a picture and dimensions of what I have tomorrow.

BryanM.

iTrader: (1)

Hmmm...Are you buying OEM seals or aftermarket?

Both the B16A3 and the B16A2 have the same part #s for both seals.

I hate to say it like this but something isn't right on your end. Either you didn't order the right seals or you weren't sent the right seals.

mouab18c1

iTrader: (5)

That's what I'm saying^^

Kova23

i checked out again. this seals are fit both for eg6 sir2 and ek4 sir jdm civics with b16a. probably your seal sizes are not factory.
what outside diameter of your seals?