CBR600OnTop

I just bought a pair of sparco seats and putting in a 5 point haress. What is he best and easiest way to install this so i dont fly through my windshield when it gives out . Thanks

PAUL

Kamin

ugh here we go again
do you have a rollbar?
im guessing you dont
please dont use a harness without a rollbar it could wind up k.illing you
how you ask?
because a stock seatbelts allows you to move forward or sideways in the event of a rollover or head-level colision. the harness will keep you planted and not allow movment.

cliff notes: stock seatbelts.



[Modified by Kamin, 6:26 PM 12/18/2002]

CBR600OnTop

I realize i will die in a roll over thanks for the thought. But i just need to know the easist and best way to install the harness.


PAUL

SIXTYdashONE

drill holes into the floor behimnd yer seats if u want to rig it in there, be gangsta

integra6650

i pulled out rear seat and where the inner belt part (the part with the butten on it) is bolt both the top ones in
the door side one i put to were the end of the seatbelt was bolted down

the center one i had to bolt in on the rear bolt of seat

all seamed sturdy to me

i only had a 4 pt i would say your gonna have to drill and thread
for the nut buster belt




[Modified by integra6650, 10:59 PM 12/18/2002]

Kamin

here is correct installation pictures
just so you know if you deviate away from this info you could be seriously injured in an accident because of the harness.





[Modified by Kamin, 9:32 PM 12/18/2002]

Ricky Rojales

Your putting yourself in danger and you don't even realize it.

https://honda-tech.com/zerothread?id=359604