i need to know B16 arp rodbolts torque spec.
#2
Honda-Tech Member
Join Date: Feb 2003
Location: schooling kids in ny, usa
Posts: 9,813
Likes: 0
Received 9 Likes
on
9 Posts
Re: i need to know B16 arp rodbolts torque spec.
10 ftlbs for the stud into the block using motor oil.
25-50-80 for the nut on top using moly lube.
this info is everywhere by the way
25-50-80 for the nut on top using moly lube.
this info is everywhere by the way
#4
Honda-Tech Member
iTrader: (1)
Re: i need to know B16 arp rodbolts torque spec.
From the instructions that i have:
1.) lube threads and nut flange face w/ provided ARP assy lube
2.) Recommended rod bolt stretch = .0075" - .0079" [preferred method]
Otherwise, torque to 40lb*ft (final). There should be a step-torque in there to like 20lb*ft first, then 40lb*ft. Loosen and re-torque. Do this a total of 3x to get sufficient rod bolt stretch.
1.) lube threads and nut flange face w/ provided ARP assy lube
2.) Recommended rod bolt stretch = .0075" - .0079" [preferred method]
Otherwise, torque to 40lb*ft (final). There should be a step-torque in there to like 20lb*ft first, then 40lb*ft. Loosen and re-torque. Do this a total of 3x to get sufficient rod bolt stretch.
#5
Honda-Tech Member
Join Date: Feb 2003
Location: schooling kids in ny, usa
Posts: 9,813
Likes: 0
Received 9 Likes
on
9 Posts
Re: i need to know B16 arp rodbolts torque spec.
whoops!
its highly recommended to have the rods re-honed to remove any ovaling of the big end after the rodbolt install. i put them in my b20 and they needed to be redone but it was like 40 bucks at the machine shop
its highly recommended to have the rods re-honed to remove any ovaling of the big end after the rodbolt install. i put them in my b20 and they needed to be redone but it was like 40 bucks at the machine shop
Thread
Thread Starter
Forum
Replies
Last Post
SrT4u2nV
All Motor / Naturally Aspirated
1
07-19-2006 04:33 PM